Care Instructions

• Locate the zipper along the bottom edge of the bed.
• Unzip completely around all sides.
• Carefully remove the cover, pulling it away from the foam insert.
• If you have the cooling pad attached, remove it from its pocket first.

Your Everyday Bed has several washable parts:

• Outer cover: the main fabric cover (machine washable).
• Waterproof liner: the inner protective layer (wipe clean or gentle wash).
• Cooling pad: the removable temperature-regulating insert (machine washable).
• Memory foam core: the orthopedic support base (spot clean only).

Machine wash on a gentle cycle:

• Use cold or warm water (not hot).
• Add a mild, pet-safe detergent.
• Avoid bleach and fabric softeners.
• Wash the cover and cooling pad separately for best results.
• For stubborn pet hair, run a lint roller over the cover before washing.
• Cozy pad: its cover is not removable. For everyday freshening, spot-clean it with mild soap and water.
• For a deeper clean, machine wash the whole cozy pad on a gentle cycle with cold water.

• For light cleaning, wipe with a damp cloth.
• For a deeper clean, hand wash or machine wash on a gentle cycle with cold water.
• Air dry only: do not put it in the dryer.
• Make sure the liner is completely dry before reassembling.

• Mix a small amount of mild dish soap with water.
• Dip a clean cloth in the solution and wring out the excess.
• Gently blot (do not rub) the affected area.
• Use a clean, damp cloth to remove soap residue.
• Allow it to air dry completely: this may take 24–48 hours.

• Cover: tumble dry on low heat, or air dry flat.
• Cooling pad: tumble dry on low heat, or air dry.
• Cozy pad: air dry completely. Do not put it in the dryer.
• Waterproof liner: air dry only (no dryer).
• Foam core: air dry completely (24–48 hours).

Important: make sure every part is 100% dry before reassembling to prevent odors.

• Place the memory foam core on a flat surface.
• Make sure the foam is completely dry.
• Check that the foam has not shifted or bunched up.

• Lay the waterproof liner over the foam core.
• Smooth out any wrinkles.
• Tuck the edges under the foam if needed.

• Place the cooling pad in its designated pocket inside the cover,
• or place it on top of the foam for extra cooling in summer.
• The cooling pad can also be removed entirely in winter.

• Open the cover zipper all the way.
• Work the corners in first: this is the trickiest part.
• Slide the foam (with liner) into the cover.
• Gently pull and adjust the cover to fit snugly around the foam.

• Zip the cover completely closed.
• Flip the bed over and smooth out any bunching.
• Give it a few good pats to fluff it up.
• Your bed is ready for your pup!